| Ryandor.com https://ryandor.com/forum/ |
|
| Ilshenar Map https://ryandor.com/forum/viewtopic.php?f=2&t=2311 |
Page 1 of 1 |
| Author: | Tintamar [ Fri May 20, 2005 10:41 pm ] |
| Post subject: | Ilshenar Map |
Was trying to map a Ilshenar and when I went to use Dragon it said the BMP was wrong size. I made the BMP 2304 X 1600 which is the Ilshenar map size. Is there something I need to change to get it to work with other maps besides tram/fel? |
|
| Author: | Dev Viperrious [ Sat May 21, 2005 4:43 pm ] |
| Post subject: | |
There are a few threads on how to use the map0.mul and do all the map design for ilshenar then use map copy to place it in the correct sized map. Dev |
|
| Author: | Tintamar [ Thu Jun 09, 2005 9:44 pm ] |
| Post subject: | |
So I have to use another program to covert to Ilshenar map? What I did was take my map0.bmp and cut it down to the right size and it didnt work. So I cut down my map.bmp for tram/fel then cut copy pasted my land on to the new sized one for ilshenar. and it still doesnt work. Is Dragon only set to compile tram/fel size maps? |
|
| Author: | Dev Viperrious [ Fri Jun 10, 2005 11:25 am ] |
| Post subject: | |
Yes Dragon only works with Tram/Fel sized maps, this is why you need UO Copy program. Take a blank Trammel map and draw an area the size of Ilshenar or Malas then create your map in that zone, compile the map then use UO Copy to "Cut" out that section and past it into your Ilshenar or Malas map. Dev |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|